A - 3
Appendix
• Support the wagon by its supporting foot.
• Slacken the nut (1).
• Unscrew the screw (2).
• Turn the threaded spindle (3).
The threaded spindle must be turned until the distance x
measured between
– the upper edge of the frame and the ground lies
between 1.29 and 1.32 m
So that the adjustment can be made,
the piston (4) of the ram must not be
fully retracted to its end stop.
• Screw in the screw (2).
• Screw up the nut (1) again.
The two rams must be adjusted
equally.
If necessary, adjust the position of the ram (1) and its
mounting (2), i.e. by using one of the holes (3) in the tow-
bar frame.
KDW02360
B
A
A1.1.4 Adjusting the angle of the towing eye
(only for top-mounted attachment)
The towing eye can be mounted in two positions so that the
coupling between the trailer and the towing eye can be as
near to the horizontal as possible to avoid problems arising
from articulating the tow-bar.
Use holes “A” or “B” depending on the height position of the
tractor hitch.
Torque settings for the mounting bolts: 1.450 Nm
To Next Page
Loading...