A - 6
Appendix
A1.3 Assembling the superstructure
Preparation
• Secure the tractor and feeder wagon against rolling
away.
• Support the wagon by its supporting foot.
• If the tractor is coupled and connected to the wagon,
switch off the engine, apply the brake and remove the
ignition key.
• Enter the wagon by the side door.
• Assemble the upper panels.
Assembly must be carried out by at
least two people.
• Swing up tubular hoops (4).
• Fasten tubular hoops (4) on each side with U profile (3),
bolt (1) and nut (2).
KDW03150
3
4
21
KDW03180
1
4
4
• Place backboard (1) on the rear flap and attach on
each side with 4 screws / plain washers (2).
KDW04340
1
2
To Next Page
Loading...