III - 9
Controls
BMII-152
BMII-153
3.11 Road Safety Switch
The road safety switch must be in road
position (II) when you drive on the road.
Move the mowers to transport position
beforehand.
This ensures that all hydraulic functions - apart from
steering and brakes - are deactivated.
I - Field position
II - Road position
3.9 Release Switch: Automative
Drive
Releases the automative drive (position II) when operated.
When the automative drive is switched
off (position I), the mower cannot be
switched on.
When operating automative drive switch
nobody is allowed in the immediate
hazard zone of the machine!
Always remove the ignition key before
leaving the cabin.
To turn off the mower:
Operate the hand brake switch.
Set the automative drive switch into off
position.
3.10 Release Switch: Axle Separation
Switches on the axle separation when operated (position
II).
The axle separation can only be acti-
vated for driving stage 1 (field position).
To Next Page
Loading...
