Krone Big M II - Setting Ground Pressure (Continued)

X - 4
Mowers
The desired cutting height can be adjusted and read off
using the air level.
 Release wing nut (1).
 Move pointer (2) to the desired angle on the angle scale
(3).
 Tighten the wing nut again.
 Adjust the mower using the setting ratchet until air
bubble (4) becomes visible at the centre of the slotted
hole.
1234567890123456789012345678901212345678901234
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1
23456789012345678901234567890121234567890123
4
1234567890123456789012345678901212345678901234
123456
1
2345
6
123456
Additional high cut skids have to be installed.
-itacidnI
no
).B.z(
laciteroeht
gnittuc
thgieh
gnikroW
snoitidnoc
°6+
°3+
mc11.ac
mc8.ac
tuChgiH
porcegarofelbarA
dnuorgtfosdnatsiom
°0
°3-
mc6.ac
mc4.ac
procegarofelbarA
snoitidnocyrd
snoitidnoclamron
°6-mc2.acwolotrewomehtgnittes
foksir
egamaddraws