4
10.3.7 Angular drive / Front mower
1
3
EC-152-0
10.3.6 Main gearbox / side mower
General
The oil of the main gearbox (1) must be changed after
100 h (end also every 100 h afterwards). Before every
use, check the oil levels in the gearboxes, the oil level
must be between the markings (3), if necessary refill oil
(SAE 90). Check for abrasion.
The used oil must be correctly disposed
of!
Oil inspection: Intervals see section 10.3.5
The dip stick (2) is located in the front
mower. It is also used to measure the oil
level of the side mowers..
Oil change: Unscrew dip stick (2).
Unscrew oil draining screw (4).
Collect the oil in a suitable vessel.
Fit oil draining screw with new seal.
Refill oil from the top (dip stick hole),
Screw in dip stick (2).
Oil quality: see section 10.3.4
Oil capacity: see section 10.3.4
Oil inspection: Intervals see section 10.3.5
Remove check screw (1)
Oil level up to bore hole
If necessary, top up oil (SAE 90), fit
check screw
.
Oil change: Intervals see section 10.3.5
Unscrew venting filter (3) and suck out oil.
Collect the used oil in a suitable
collection vessel.
Refill oil from the top (oil level up to bore
hole (1)).
Oil quality: see section 10.3.4
Oil capacity: see section 10.3.4
To Next Page
Loading...
