X - 18
Mowers
10.4.5 Replacing the lining
Heavily damaged linings (see
illustration) must be replaced
immediately to prevent any risk of
damage to the cutterbar.
Adapt the new lining (3)..
Weld short I-seams on the upper surface of the
cutter bar in the areas marked (1) (each should be
approx.30 mm)
Do not weld the edges (2).
On the lower surface of the cutter bar, weld the
lining (3) along the whole length in area (5) with the
cutter bar.
Do not weld the edges (4).
Adjust the welding current and the
welding material to the cutter bar materi-
al and to the lining or carry out a trial
welding if necessary.
EC-0-010
EC-0-012
Open the seam of the old lining.
Disassemble the lining.
Trim the bearing surface.
To Next Page
Loading...
