Operation
163
Pos: 30.17 /BA/Bedienung / Großpackenpresse/ Preßkraftregu lierung @ 20\mod_123866302 3491_78.doc @ 224478
9.7 Baling Force Regulation
BP1213001
Fig. 97
The baling force in the baling channel is regulated by an electronic hydraulic system. The
setting of the baling force is made by the control unit of the tractor (refer to chapter “Setting the
target bale channel flap pressure”).
The pressure can be metered directly from the display of the control unit.
An additional pressure gauge (1) for metering the baling pressure is located on the left side of
the machine under the side hood on the pressure limitation valve.
Note
Retaining the baling pressure when the control unit (medium/comfort) is switched off
In order to conserve the baling pressure in the bale channel chamber, the control unit may be
switched off only after the machine or the flywheel have come to a complete standstill.
Pos: 30.18 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
