Krone Big Pack 890 HS - Activating the Bale Ejector; Medium Version; Comfort Version

Operation
165
Pos: 30.21 /BA/Bedienung / Großpackenpresse/ Ausschieben des letz ten Ballens T2 HS Baureihe @ 63\ mod_1299678915504_78. doc @ 574678
9.8.2 Activating the bale ejector
Fig.99
9.8.2.1 Medium version:
• Activate the bale ejector (1). In the Medium version, the bale ejector is activated via the
upper control lever (3) on the rear left of the machine.
To do this:
• Open the shut-off valve (5) (see figure).
• Open the shut-off valve (4) (position I).
• Raise the safety sleeve (2) and move the control lever (3) to position (a) or (b).
Position (a): The bale ejector (1) moves forward.
Position (b): The bale ejector (1) moves back.
Note
After ejection of the bale it is essential to move the bale ejector to the forward position again.
To do this, move the control lever (3) to position (a) as described above. Finally, close the shut-
off valves (4, 5).
9.8.3 Comfort version:
In the case of the Comfort version, this function can be activated from the control unit or using
the machine buttons (see Section Starting Screen Manual Mode 2/2 'Automatic bale ejector
system').
Pos: 30.22 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165