Krone Big Pack 890 HS - Setting Packer to Baling Ram; Setting the Packer

Settings
208
Pos: 32.105.12 /BA/E instellungen/Großpac kenpresse/Pr esskolbeneinstellun g/Raffer zum Preßko lben einstellen mit Hin weis @ 24\mod_12414245910 86_78.doc @ 243867
10.10 Setting packer to baling ram
Note
The packers only need to be set when the packer gearbox or the chain coupling connection
chains have been loosened.
Pos: 32.105.13 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellun g/Einrastung der Reib kupplung überprüfen HS Baureihe @ 63\mod_12996864 66008_78.doc @ 575119
Fig.149
• The packer coupling is properly engaged when the outer marking (1) on the packer
coupling is aligned with the marking (2) on the inner ring of the packer coupling.
Pos: 32.105.14 /Übersc hriften/Übersc hriften 3/A-E/Ei nstellung Raffer @ 24\mod_124 1425604165_78.doc @ 243941
10.10.1 Setting the packer
Pos: 32.105.15 /BA/E instellungen/Großpac kenpresse/Pr esskolbeneinstellun g/Hinweis VFS_Syste m muss sich in Nullstel lung befinden @ 24\mod_124143 0475868_78.doc @ 244219
Note
Make certain that the variable filling system (VFS) system is in zero position (refer to chapter
Variable filling system (VFS) "Setting the zero position”).
Pos: 32.105.16 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellun g/Raffer einstelle n Big Pack 890 Bild @ 57\mod_129646 3263598_78.doc @ 550609
10
BPXC0319
1
9
10
Fig. 150
Pos: 32.105.17 /BA/Ei nstellungen/Großpac kenpresse/Pressko lbeneinstellun g/Raffer einstelle n BigPack 890 @ 57\mod_129646 6244641_78.doc @ 551047
Turn the packer manually in the working direction by turning the flywheel until the large packer
strip roller (9) running in front of the feeder strip (1) is located just behind the viewing window
(10).
Pos: 32.105.18 /BA/- ----Seitenumbruc h------ @ 0\mod_119617531 1226_0.doc @ 4165