Settings
218
Pos: 32.111 /BA/Einste llungen/Großpacken presse/Einstel lung der Schwungradreini gung (nur bei Big Pac k 890) @ 24\mod_1241439733852_78. doc @ 244873
10.12 Setting the flywheel cleaning (only on BiG PACK 890)
Fig. 159
Even minor accumulations of dirt inside the flywheel (1) can result in imbalances. For this
reason, you should regularly check the setting of the plastic rail (2). If the gap between the
flywheel and the plastic rail is too big, loosen the nuts (5) on the support (4) and push the plastic
rail in the oblong holes (1) up to the flywheel. Tighten the nuts again.
Pos: 32.112 /BA/Einste llungen/Großpacken presse/Grundeins tellung der Bandbrem se (Schwungrad) @ 24\mod_12414 40070086_78.doc @ 244924
10.13 Basic setting of the band brake (flywheel)
BPXC0168
1
a
Fig. 160
The band brake is positioned on the left side of the flywheel. If the braking action is no longer
adequate when the band brake is applied, it can be readjusted by lengthening the spindle (1).
Basic setting: Dimension a = 182 mm
Pos: 32.113 /BA/-- ---Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
