Maintenance
238
Pos: 34.39.1 /Überschr iften/Überschr iften 2/P-T/Presskr aftregelung (bei Not- Hand-Betätigung) @ 24\ mod_1241612862815_78.d oc @ 246772
11.14 Pressing force control (with emergency manual activation)
Pos: 34.39.2 /BA/W artung/Großpackenpres sen/Hydraulikan lage / Bordhydraulik/ Gefahr - Presskraftregel ung im Notbetrieb @ 24\mod_1 241608452018_78.d oc @ 246649
DANGER! – Pressing force control in emergency mode!
Effect: Danger to life, injuries or damage to the machine.
• If the electronics fails, you can continue to work with the baler for a short time in
emergency mode
• The pressure adjustment of the bale channel chamber flaps can be made in emergency
mode while the machine is running. Special caution must be exercised when making the
adjustment. There is great risk of injury!
• Ensure that the machine can be turned off immediately in case of danger
• The maximum pressing force can be exceeded without an electronic control system. This
can result in significant damage. Never work for a long time without the electronic control
system
Pos: 34.39.3 /BA/W artung/Großpackenpres sen/Hydraulikan lage / Bordhydraulik/Ei nstellen Pressdruck / Presskanal lösen Bild @ 24\ mod_1241612327331_78. doc @ 246699
Fig. 173
Setting the baling pressure Releasing the bale channel
chamber
Pos: 34.39.4 /BA/W artung/Großpackenpres sen/Hydraulikan lage / Bordhydraulik/ Hinweis Rändelschraube gan z herausdrehen @ 24\mod_ 1241613166065_78.doc @ 246845
Note
After emergency manual activation has been performed, the knurled head screw (2) must be
completely screwed out again.
Pos: 34.39.5 /BA/W artung/Großpackenpres sen/Hydraulikan lage / Bordhydraulik/Ei nstellen des Pressdruc kes @ 24\mod_1241612910315 _78.doc @ 246797
11.14.1 Setting the baling pressure
The baling pressure on the bale channel chamber flaps can be adjusted on the hydraulic control
block (1) on the left side of the machine under the side hood.
To perform a setting:
• Set the desired pressure by slowly screwing in the knurled head screw (2) (the pressure
is limited to a maximum of about 100 bar / 1450 PSI)
• Read the pressure on the pressure gauge (4)
Pos: 34.39.6 /BA/W artung/Großpackenpres sen/Hydraulikan lage / Bordhydraulik/Pr esskanal lösen (Komfor t) @ 24\mod_1241613287 237_78.doc @ 246869
11.14.2 Releasing the bale channel chamber (comfort)
The "Release bale channel flaps" seat valve is located on the right next to the hydraulic control
block (1) for pressing force control on the left side of the machine under the side hood.
To perform a setting:
• The bale channel chamber flaps loosen by slowly screwing in the knurled head screw (2)
as far as it will go
Pos: 34.40 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
