II - 3
Safety
2.2.5 Hitched Implements
1. Secure implements against rolling away.
2. Observe the max. permissible supporting load of
the hitch coupling, swinging drawbar or hitch!
3. In the case of drawbar coupling pay attention to
sufficient mobility at the coupling point!
2.2.6 PTO Operation
1. Only PTO shafts specified by the manufacturer
may be used!
2. The protective tube and protective funnel of the
PTO shaft as well as the PTO shield - also on the
implement end - must be attached and in proper
condition!
3. Make sure that the required tube covers for PTO
shafts are in place in transport and working
position!
4. Before installing or removing PTO shafts, switch
off the PTO shaft, turn the engine off and remove
the ignition key!
5. When using PTO shafts with an overload or free-
wheel coupling that is not covered by the
protective equipment on the tractor, the overload
or free-wheel couplings must be attached to the
implement!
6. Always make sure that the PTO shafts are
mounted correctly and secured properly!
7. Secure the PTO shaft guard against turning by
hooking in the chains!
8. Before engaging the PTO make sure that the
selected PTO speed of the tractor agrees with the
permissible speed of the implement!
9. Before engaging the PTO make sure that no one
is in the hazardous area of the implement!
10. Never switch on the PTO with the engine turned
off!
11. While working with the PTO, nobody is permitted
to stay in the range of the turning PTO or PTO
shaft.
12. Always switch off the PTO in the case of
excessive bending and if the PTO is not required!
13. Caution! After switching off the PTO, there is
danger due to the inertia of the flywheel mass!
Keep away from the implement during this time.
The machine may be worked on only if it is
completely at standstill and if the flywheel is
secured by the holding brake.
14. Cleaning, lubricating or adjusting PTO driven
implements or the PTO shaft only with PTO
disengaged, engine turned off and ignition key
withdrawn! Apply the holding brake on the
flywheel.
15. Place the uncoupled PTO shaft on the holder
provided!
16. After removal of the PTO shaft, fit the protective
sleeve on the PTO stump!
17. Immediately repair any damage before working
with the implement.
18. Release the flywheel brake before the PTO is
turned on.
2.2.7 Hydraulic System
1. The hydraulic system is pressurised!
2. When connecting hydraulic cylinders and motors
pay attention to the specified connection of the
hydraulic hoses!
3. When connecting the hydraulic hoses to the
tractor hydraulics take care that the hydraulics are
pressureless both on the tractor side and on the
implement side!
4. In case of hydraulic function connections between
tractor and machine coupling sleeves and plugs
should be marked so that faulty operation is
excluded! On changeover of the connections
reversed function (e.g. raising/lowering) - Danger
of accident!
5. Check the hydraulic hose lines at regular intervals
and replace them if damaged or worn! The new
hoses must comply with the technical
requirements set by the manufacturer of the
implement!
6. When searching for leaks, use suitable aids to
avoid the risk of injuries!
To Next Page
Loading...
