III - 13
Start-up and Transport
The release valve is on the front right under the side
hood. If a minimum pressure of 4 bar is available in the
storage tank (2) of the brake system of the Big Pack
Baler, then the brake can be released by pressing the
push button (1) on the release valve into the position (a).
As soon as the hoses are connected to a compressed
air brake system again, the push button is pushed back
automatically into its starting position (b).
If the air pressure in the storage tank (2) has dropped
below 4 bar, the residual pressure must also be let off by
operating the drain valve (3). Only now can the Big Pack
Baler be moved.
Secure the machine against rolling away
before operating the release valve or
letting off the air pressure from the
storage tank.
Check the lighting system:
• Check the rear lights (2) and reflectors (1) for proper
functionality and clean them.
• The same applies to the yellow reflectors located on
the sides of the Big Pack Baler and the front white
side lights.
Hydraulically activated roller chute (optional):
• Fold up the hydraulically activated roller chute
hydraulically.
After it is folded together, make certain that the
mechanical lock has snapped into place.
1
BPXC0122
2
1
2
BPXC0123
1
3.7.2 Moving
If the hoses of the compressed air brake are not
connected to a brake system, then the Big Pack Baler
cannot easily be moved.
Moving the Big Pack Baler in public road
traffic without the compressed air brake
connected is prohibited!
BPXC0212
3
2
1
1
a
b
To Next Page
Loading...
