Safety
18
Pos: 11 /Überschri ften/Überschrift en 1/P-T/Sic herheit @ 0\m od_119556674 8646_78.docx @ 635 @ 3 @ 1
3 Safety
Pos: 12 /Überschri ften/Überschrift en 2/U-Z/VV erwendungsz weck @ 1\mod_ 120170724673 8_78.docx @ 5 4055 @ 2 @ 1
3.1 Purpose of Use
Pos: 13 /BA/Masc hinenbeschrei bung/Maschin enübersicht/Groß packenpressen/ Verwendungsz weck BiG Pac k HS Baureihe @ 93\mod _132732368828 8_78.docx @ 78 6957 @ @ 1
KRONE Big Pack square balers are machines for collecting and baling cut crops (grass, hay,
leguminous vegetation and straw, etc.) on farms. They are towed behind agricultural tractors of
sufficient power that are also equipped with suitable interfaces for the installation and operation
of the machine (see the introductory chapter "Technical Data" / "General Technical Description).
The crop must be set down in rows on the field to be collected. Then it must only be collected
with the pick-up by driving over the swath.
Pos: 14 /BA/Masc hinenbeschrei bung/Maschin enübersicht/Groß packenpressenA ufnahme u nd Pressung nich t genannter Pr essgüter @ 341\mod_14327 13531296_78.d ocx @ 2587 516 @ @ 1
WARNING! – Intake and baling of crops not mentioned!
Effect: Damage to the machine
Collecting and baling materials that are not cited here is permitted only in agreement with the
manufacturer. The basic requirements in any case are swathing of the crops and automatic
intake by the pick-up as it passes over them.
Pos: 15.1 /Übersc hriften/Übersc hriften 2/A-E/B Bestimmungsg emäßer Gebr auch (alt) @ 0\ mod_1196401 545090_78.doc x @ 7728 @ 2 @ 1
3.2 Intended Use
Pos: 15.2 /BA/Einl eitung/Besti mmungsgemäßer Gebrauch/Gross packenpresse /Bestimmungsge mäßer Gebra uch BiG Pack @ 93\mod_ 13273246924 81_78.docx @ 787 043 @ @ 1
The Big Pack square baler is built exclusively for customary use in agricultural work (see the
introduction "Intended Use").
The machine must only be used by persons who meet the requirements listed in the chapter on
safety "Personnel Qualifications and Training".
These operating instructions are part of the machine. The machine is designed exclusively for
use in accordance with these operating instructions.
Using the machine for work or applications that are not described in these operating instructions
can lead to severe injuries or death of persons and damage to the machine and other property.
Such work and applications are prohibited.
Pos: 15.3 /BA/Einl eitung/Besti mmungsgemäßer Gebrauch/Nicht bestimmungsge mäß @ 103\ mod_133217 1672294_78.d ocx @ 940272 @ @ 1
Unauthorised modifications to the machine may have a negative effect on the machine
characteristics or safe and reliable use of the machine or may interfere with proper operation.
Unauthorised modifications shall therefore release the manufacturer of any liability for
consequential damage.
Pos: 16 /Überschri ften/Überschri ften 2/K-O/NNu tzungsdauer der Maschin e @ 318\mod_14 23658430909 _78.docx @ 2465 744 @ 2 @ 1
3.3 Service life of the machine
Pos: 17 /BA/Einl eitung/Nutzungsd auer der Masc hine_Text @ 318\mod_142 3556613022_ 78.docx @ 246 3145 @ @ 1
– The service life of this machine strongly depends on proper use and maintenance as well as
the operating conditions.
– Permanent operational readiness as well as long service life of the machine can be
achieved by observing the instructions and notes of these operating instructions.
– After each season of use, the machine must be checked thoroughly for wear and other
damage.
– Damaged and worn parts must be replaced before placing the machine into service again.
– After the machine has been used for five years, carry out full technical inspection of the
machine. According to the results of this inspection, a decision concerning the possibility of
reuse of the machine should be taken.
– Theoretically, the service life of this machine is unlimited as all worn or damaged parts can
be replaced.
Pos: 18 /Layout M odule /---------------Seitenumbruch---------------- @ 0\mod_119617531 1226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
