Krone Big Pack 890 XC - Page 242

Terminal – Menus [Medium/Comfort Version Electronics]
242
No./symbol
Possible cause
Remedy
29
– The axle is not locked.
– The "Lock axle" sensor is
defective.
• Check the hydraulic connection.
• Check the sensor and replace if
required.
30
– The knotter 7 or 8 is not
functioning properly.
– The "Knotter" sensor has been
incorrectly set.
• Check the knotter and knotter
triggering.
• Correctly set the sensor.
31
32
– The slip is too great.
– The "Knotter" sensor has been
incorrectly set.
– The cutting unit is blocked.
• Correctly set the sensor.
33
– The pressure is too high.
– The "Feed rotor" sensor is
defective.
• Check the hydraulic system.
• Check the sensor and replace if
required.
34
– The "PTO speed" sensor has
been incorrectly set.
• Correctly set the sensor.
35
– The "Twine box" sensors have
been incorrectly set.
– The twine boxes have not been
raised.
• Correctly set the sensors.
• Raise the twine boxes.
36
– The crops are too moist.
• Check the setting and correct if
required.
37
– The PTO speed is too high.
• Switch off the PTO shaft.
Pos: 103.319 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_119 6175311226_0. docx @ 4165 @ @ 1