Krone Big Pack 890 XC - Setting the Height of the Needles on the Knotter

Operation
256
Pos: 107.21.13 /Üb erschriften/Üb erschriften 3/U-Z /Unterfa den einfädeln @ 154\mod_136 3274391674_78 .docx @ 136909 4 @ 3 @ 1
18.2.3 Threading in the Lower Twine
Pos: 107.21.14 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Unt erfaden vom G arnkasten zur unteren Garnfü hrung weiterf ühren. @ 154\ mod_13632745 02562_78.doc x @ 1369122 @ @ 1
Then guide the lower twine from the twine box to the lower twine guide.
Pos: 107.21.15 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Bin deeinrichtung 4 D oppelknoter 8 90 HS/Unterfade n einfädel n Bild 1 890 HS @ 191\mod_ 138190156018 7_78.docx @ 1 632716 @ @ 1
86
1 2
BPHS0233
2 1
87
88
2
1
Fig.
153
Pos: 107.21.16 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Bin deeinrichtung 4 D oppelknoter 8 90 HS/Unterfade n einfädel n T1 2 Unterfäd en @ 191\ mod_1381846595 287_78.docx @ 1 632486 @ @ 1
Make certain the lower twines never cross.
• Guide the both lower twines (1,2) coming from the twine box (6) to the twine guide top (7).
• Guide the both lower twines from the top through the eyes of the twine guide top and then
guide them to the frame twine guide (8).
• Guide the both lower twines from the outside through the eyes of the twine guide frame and
further to the lower twine brakes.
Pos: 107.21.17 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Unt erfaden von d er unteren Garnf ührung zu de n Nadeln weit erführen @ 154 \mod_1363274 809338_78.doc x @ 1369226 @ @ 1
Then guide the lower twine from the lower twine guide to the needles.
Pos: 107.21.18 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Bin deeinrichtung 4 D oppelknoter 8 90 HS/Unterfade n einfädel n Bild 2 890 Hs @ 191\mod_ 13819018987 93_78.docx @ 16 32775 @ @ 1
BPHS0225
1
2 3
8
7
10
9
12
13
11
Fig.
154
Pos: 107.21.19 /B A/Einstellung en/Großpackenpre sse/Bindegar n einfädeln/Bin deeinrichtung 6 D oppelknoter/U nterfaden einfä deln T2 4 x4/ BiG PACK 1 270 HS @ 303\ mod_14144161 56224_78.doc x @ 2359223 @ @ 1
• Release the twine brake (8).
• Thread the lower twine coming from the twine guide frame through the lower eye (7) and
attach it on the brake rolls.
• Rotate brake rolls manually. In this process, the twine is guided through the brake rolls.
• Thread the lower twine through the eye of the twine brake (8) cover.
• Guide the lower twine further through the eye of the twine tension springs (10).
• Pull the lower twine up and guide it between the rolls (11) of the needle (12).
• Pull the lower twine down to the frame (13) and knot it on the frame.
Pos: 107.21.20 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1