Krone Big Pack 890 XC - Page 466

5 Safety routines
5.3 Safely perform oil level check, oil and filter element change.
22
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
5.3 Safely perform oil level check, oil and filter element change.
WARNING
Safely perform oil level check, oil and filter element change.
The operational safety of the machine can be affected if oil level check, oil and filter element
change are not performed safely. This may result in accidents.
Safely perform oil level check, oil and filter element change.
In order to check the oil level and change oil and filter element safely:
 Lower raised machine parts and secure them against lowering,refer to page21.
 Shut down and safeguard the machine, refer to page21.
 Observe the intervals to check oil and change oil and filter elements, .
 Only use oil quality/amount of oil mentioned in the fuel table, .
 Clean the area around the parts (e.g. gearbox, high-pressure filter) and make sure that no
foreign bodies get into the parts or hydraulic system.
 Check existing seal ring for damage and replace it, if necessary.
 Collect leaking oil or waste oil in a special container and dispose of it properly, refer to
page17.
5.4 Running actuator test
WARNING
Run actuator test safely
When actuators are energised, functions are carried out directly and without a safety prompt.
This may cause the unintentional movement of machine parts, trapping and seriously or
fatally injuring persons.
ü Only persons familiar with the machine are permitted to perform the actuator test.
ü The person performing the test must know which machine parts are activated by
controlling the actuators.
 Run the actuator test safely.
To run the actuator test safely:
 Lower raised machine parts or secure them against falling, refer to page21.
 Shut down and secure the machine, refer to page21.
 Cordon off the danger zone of the actuated moving machine parts in a clearly visible
manner.
 Ensure that there is nobody in the danger zone of the actuated moving machine parts.
 Switch on the ignition.
 The actuator test must only be performed from a safe position outside the area that is
affected by machine parts moved by the actuators.