Krone Big Pack 890 - Baling Force Regulation

VII - 6
Working with the Big Pack Baler
The shut-off valve (1) is used to release
the baling channel.
The machine is in the working position in
setting (a).
To release the baling channel, use
position (b) (tank return)
If the shut-off valve is in position (b), it is
not possible to build up pressure.
In the case of the Comfort design, this function can be
switched from the control unit or on the machine buttons
(see Chapter 4).
Comfort design:
The pressure can be read directly on the control unit
(see Chapter 4 and 5).
An additional pressure gauge (1) is located on the left
side of the machine under the side hood on the pressure
limiting valve.
Shut-off valve for releasing the baling
channel
For the Medium designs:
BPXC0138
1
a
b
7.4 Baling Force Regulation
The baling force in the baling channel is regulated by
an electronic/hydraulic system. The force of pressure
can be adjusted from the tractor controls.
Retaining the baling pressure when the electronics
(medium/comfort) are switched off
In order to conserve the baling pressure
in the bale channel chamber, the
electronic system may be switched off
only after the machine or the flywheel has
come to a complete standstill.
BP1213001
1