I - 8
General Information
PTO speed 1000 rpm
PTO shaft Tractor side: Wide-angle
Machine side: Free-wheeling clutch
Hitch Hitch coupling; swinging drawbar
(perm. supporting load 1,300 kg; XC = 1,900 kg)
(drawbar adjustable in height)
Caution! When an adjustment is made, the hexagon
head screws must be tightened to the torque show in the
“Tightening torques” table in Chapter 8.2.
Support Support base, retractable - manually adjustable in height.
Optional: Hydraulic support base
Uncontrolled pick-up (EasyFlow) drum Hydraulic lift
Height adjustment by perforated bar on the supporting
wheel.
Tine mounting: 5
Number of tines: 16 (20) double tines/tine mounting
Lateral feed Right and left worm conveyor
Variable crop feed (VFS) Forced intake by feed packer drum
Feed packer drum with: 5 feed packers and
1 switching feeder packer
With the XC design, there is also a cutting system up front.
Baling ram Length of stroke 750 mm
-50 strokes per minute (Big Pack 890)
- 38.5 strokes per minute (Big Pack 1270 and 1290)
The baling ram moves on 4 rollers
5/7 blades on the baling ram
Setting the baling density Electronic/hydraulic force control (both
adjustable from the tractor)
Twine box on both sides, for a total of 32 balls of twine
Twine Synthetic twine (110-130 m/kg)
For twine roll end and torn twine Electrical twine control with acoustic and optical signal.
Bale ejector/bale unloading One-part bale chute (must be folded up
in transport).
Operation according to Medium - Comfort version
at the machine or from the tractor
Holding brake Operation by hand crank at the rear left of the baler
1.6 General Technical Description
To Next Page
Loading...
