Start-up – additional axle
493
13.1.2 Installing the additional axle
Fig. 420
• Reverse the machine and position it above the additional axle (1)
• Raise the additional axle (1) with a car jack (2)
• Install the front bolt (3) of the axle suspension on both sides
Fig. 421
• Hook the cable winch into the additional axle and raise it so that the upper bolts (2) of the
hydraulic cylinder can be installed
• Unhook the cable winch and retract it all the way
• Hook in the cable harness (1)
• Install the hydraulic lines (3) (quick release)
• Connect the plug of the sensor (4)
• Check the function of the additional axle, see page 495.
To Next Page
Loading...
