Start-up – Attaching and removing the front attachment
503
15.1 Adapting the adapter frame of the front attachment
The locating points of the different front attachments must be adapted to the locating points of
the pendulum frame before they are installed for the first time.
Fig. 434
• Measure the axle base "a" between holding claw (1) and locking hook (2) on the pendulum
frame of the forage harvester.
Fig. 435
• Measure the centre distance "a" between the locating bolts (1, 3) on the adapter frame on
the front attachment.
The distance "a" on the pendulum frame and adapter frame must be set to the same dimension:
• Loosen the screw connections (2) on the right/left and shift the pendulum frame holders (3)
to the correct distance.
• Tighten the screw connections (2).
To Next Page
Loading...
