Operation
565
Reverse the intake/front attachment with chopping drum switched off
For larger blockages, the intake/front attachment must be reversed with the chopping drum
switched off. This prevents the drives from overloading. The main coupling can only be
connected after the entire crop flow has been checked and any blockages have been cleared.
Prerequisites:
– The driver's seat is occupied.
– The engine has been started.
– The release switch road/field is in the "field mode" setting.
– The release switch "maintenance" is switched off.
– The release switch "intake/header" is switched on.
– The main coupling is switched off.
– The quick-stop switch console is not actuated
– The quick-stop switch manual operation is not actuated
– The actuator test in menu 4-1-1 must not be active.
To reverse the intake/front attachment from the driver's seat:
• Press and hold down the "Reverse intake/front attachment" key (2) on the multi-function
lever.
The front attachment and the feed drive rollers will reverse for as long as the "Reverse
intake/front attachment" key (2) is pressed.
The "Reverse intake/front attachment" key (2) on the multi-function lever can be pressed even
when the intake/front attachment is switched on. Then the intake/front attachment must be
switched on again.
To Next Page
Loading...
