Operation
571
18.5.9 Traction control system
The traction control system (TC) is used to prevent the wheelspin (slip) in specific situations. It
can be set at two levels.
TC I allows increased slip. This setting is usually used in maize mode to ensure adequate
forward drive even under difficult conditions.
TC II only allows limited slip.This setting is usually used in grass mode to protect the sward.
Turning on the ignition automatically switches on the traction control system.
Activating the traction control system and setting the sensitivity level
Fig. 503
• Repeatedly pressing the TC key (1) switches the traction control system off or on.
• Repeatedly pressing the "TC I/II" key (2) switches the sensitivity level.
The status of the traction control system is shown in the display, see page 173.
To Next Page
Loading...
