Maintenance - Gearbox
728
26.1.4 Maintenance of angular gearbox
NOTE
Check oil level and change the oil when the feed drive housing cover is in a horizontal position.
Oil level check
Machine no. 83 3001-879999 Oil le vel check
Fig. 684
• Thoroughly clean the area around the oil dip stick (1).
• Unscrew the oil dip stick (1) and remove any oil residue using a lint-free, clean cloth.
• Screw in the oil dip stick (1) and unscrew it again.
• Read the oil level.
• The oil level must be between the markings "MIN" and "MAX", if necessary top up oil
(see Oil change).
• Screw in the oil dip stick again.
Oil change
• Provide a collecting vessel (approx. 5 litres).
• Thoroughly clean the area around the oil drain plug (2).
• Dismount the oil drain plug (2) and drain the oil.
• Unscrew the oil dip stick.
• Re-attach the oil drain plug (2).
• Add the oil. Type of oil and filling quantity, see page 104.
• Screw in the oil dip stick again.
To Next Page
Loading...
