Krone BiG X 600-3 - Page 765

Appendix – CropControl System
8
Pos: 10.5 /BA/Info-Center/CropControl BiG X 600-1100-1/Statuszeile 1 @ 428\mod_1455267413483_78.docx @ 2963985 @ @ 1
Status line (I)
Current CropControl states are shown in the top line (I) of the display.
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
Fig. 6
Possible status displays:
Graphic
Meaning
Information
Alarm message present.
1
Currently active cultivated area.
Cultivated areas 1-50 exist.
1
Currently active counterweighing for
the displayed cultivated area
A total of 500 counterweighing
operations can be carried out.
CropControl counts yield.
The following conditions must be
fulfilled to enable CropControl to
count yield:
– Intake is rotating
– Header in working position
– Machine moves forward
– The excursion of the pre-
compression rollers is more than
the set minimum excursion.
Cultivated area is active, but
CropControl is not counting yield.
The machine is not currently
harvesting, or insufficient crops are
passing through the machine.
Pos: 10.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1