Krone BiG X 770-3 - Page 203

Info centre "EasyTouch"
203
Arbeitsbreite Direktschneidwerk einstellen
5 6
7 8
B C D
BX500026_1
Abb. 147
• Mit dem Inkrementalgeber die Einstellung Arbeitsbreite anwählen. Das Auswahlfeld wird
farblich hervorgehoben.
• Den Inkrementalgeber drücken, um in das Auswahlfeld zu springen.
• Mit dem Inkrementalgeber die gewünschte Arbeitsbreite einstellen.
• Press the incremental encoder to accept the setting and to exit the selection box.
• To exit the settings mask, press the
D
key or the key on the incremental encoder.
Setting the lifting unit control for the direct cutting system
The direct cutting system is always operated using the "ground pressure control" control type,
which can be used to achieve an optimum cutting profile.
5 6
7 8
B C D
BX500027_1
Fig. 148
• You can use the incremental encoder to choose the lifting unit control setting. The selection
box is highlighted in colour.
• Press the incremental encoder to jump to the selection box.
• You can use the incremental encoder to set the required lifting unit control.
• Press the incremental encoder to accept the setting and to exit the selection box.
• To exit the settings mask, press the
D
key or the key on the incremental encoder.