Info centre "EasyTouch"
267
Adjusting process 1 "lower height" - calibration of the lower height of the lifting unit
Fig. 200
• Press the "Lower lifting unit" key (2) and memory key for "Lifting unit adjusting process" (1)
and hold down simultaneously for approx. 7 seconds. The lifting unit is lowered all the way.
– After successful adjustment, the message "Lifting unit control adjusting process 1 OK"
appears in the status line of the terminal.
Checking actual ground pressure
• Select menu 4-1-5, display 4 "Calibration values".
• Move the lifting unit up and down at least twice.
• Leave the lifting unit in a suspended position (no contact with ground) and read off
the "actual ground pressure" value next to the
symbol.
NOTE
The "actual ground pressure" value must have a negative percentage value. If the percentage
value is positive, the adjusting process 2 must be repeated.
To Next Page
Loading...
