Info centre "EasyTouch"
294
8.6.8.1 Calibrate feed drive/front attachment
The intake must always be calibrated if
– a new intake was mounted.
– the actual chop length deviates from the displayed chop length.
– the KMC2 control unit was replaced.
– if work was performed on components of the intake drive (pump, hydraulic motor or speed
sensor).
The front attachment must always be calibrated if
– a new front attachment was mounted.
– the actual header speed deviates from the setpoint speed.
– the KMC2 control unit was replaced.
– if work was performed on components of the front attachment drive (pump, hydraulic motor
or speed sensor).
NOTE
Always calibrate the intake and front attachment together.
NOTE
The intake should only be calibrated if the actual chop length differs from the displayed chop
length.
NOTE
The front attachment should only be calibrated if the actual speed deviates significantly from the
setpoint speed (on a once-off basis by fitter or after replacement of the job computer).
Prerequisites:
– Release switch road/field is switched to field mode
– Release switch traction drive is switched off
– Release switch "intake/header" is switched on
– Release switch maintenance is switched off
– Seat switch is actuated (the driver's seat is occupied).
– Diesel engine running at rated speed
– Lifting unit is in working position
– Main coupling is switched on
To Next Page
Loading...
