Krone BiG X 770-3 - Menu 4-1-3 CAN Bus

Info centre "EasyTouch"
318
8.8.1.4 Menu 4-1-3 CAN bus
Fig. 241
• Select menu 4-1-3 “CAN Bus”.
The “CAN Bus” diagnostics menu is divided into two displays:
–
Display 1
“CAN bus participant”
–
Display 2
“Terminating resistor CAN bus 2”
Display 1 "CAN Bus user"
Fig. 242
Display 1 "CAN Bus user" shows the current connected control units (participants) at the CAN
bus. In the event of an error, the relevant participants are shown in red with an exclamation
mark. An error message is also displayed on the terminal.

NOTE
For error correction, contact your dealer or KRONE customer service.
Sample illustration of an error at the CAN bus:
KMC2 active
KMC2 inactive or disconnected from CAN bus