Info centre "EasyTouch"
438
8.17.3 Automatic mode
In Automatic mode, the silage additives is dosed depending on time or crop throughput (with
CropControl only). Here, the pumping of silage additives is switched off when the machine is not
chopping.
The active pumping of silage additives is indicated by a green background colour on the status
display.
Automatic mode active. Silage additives pumping inactive.
Automatic mode active. Silage additives pumping active.
BXSI00002
5
6
7
8
B
C
D
1
2
3
4
8
9
10
7
6
5
Fig. 339
In Automatic mode, the dosing of silage additives can be affected by adjusting input fields 6 and
7.
In input field 6 the unit can be set first, according to which the silage additives are to be dosed.
The following settings are possible:
Dosing quantity per unit of time (litres per minute)
Dosing quantity per unit of weight (litres per tonne) (with CropControl only)
The value in input field 7 combined with the unit in input field 6 results in the required dosing of
the silage additives unit.
The actual throughput must therefore be set in input field 7. The setting in input field 7 can also
be adjusted by pressing the
and keys.
Notice
The maximum throughout of the silage additives unit must not be exceeded.
Conditions for the setting "dosing quantity per unit of weight"
• The setting "dosing quantity per unit of weight" is available for the "CropControl (yield
recording)" version only.
• CropControl must have been calibrated.
• If the CropControl does not record and output any yield, no silage additives are being
injected with this setting. If silage additives are nevertheless to be injected, the setting must
be set to "dosing quantity per unit of time".
To Next Page
Loading...
