Start-up - Grass mode
455
Removing the corn conditioner
Fig. 351
• Relieve the power belt (2). To do this push the tension roll (4) back manually.
• Remove the power belt (2) from the belt pulley (3).
Fig. 352
• Move the cable winch hook (2) through the rope guide (1) and hook it in the corn
conditioner (3).
• Pull up the rope with the cable winch until it is taut.
• Loosen the screw connection for central lubrication (4).
• Loosen the plug connection (5) of the adjusting motor.
• Fit a clean filler plug to guard the plug.
To Next Page
Loading...
