Start-up - Grass mode
457
Fig. 355
• Dismount the safety plates (3) on both sides of the corn conditioner hooks.
• Pull corn conditioner up by using the cable winch until the hooks from the forage harvester
holder are released.
• Lower corn conditioner with cable winch and place it securely on the installation carriage.
Make certain no lubrication lines are crushed.
• Dismount the cable on the corn conditioner and push out the installation carriage to the
right-hand side of the machine.
Close the stop cock for the corn conditioner tension roll
Fig. 356
The stop cock (1) for the corn conditioner tension roll must be in the position I (closed).
• If necessary, close the stop cock (1) (position I).
To Next Page
Loading...
