Start-up - Grass mode
458
11.3 Installing the grass channel
WARNING! – Risk of injury due to suspended load!
There is a danger for persons due to falling load.
• Pay attention to sufficient carrying load of the hoist.
• Do not stay under the suspended load.
Prerequisites for installation and removal:
– Diesel engine is switched off.
– The side flap at the front right is open.
– The machine is shut down and safeguarded, see chapter Safety, "Shutting down and
safeguarding the machine".
Fig. 357
• Undo the lock (1) and swivel open the tool box (2).
• Remove the protective lid (4) between the discharge accelerator housing and the tank
cover.
• Make certain the discharge accelerator rear is secured on the left and rights side by two
spring locks (3).
Fig. 358
• Dismount the screws of the service cap (1) on the right side of the machine and remove the
service cap.
To Next Page
Loading...
