Start-up - Grass mode
459
Fig. 359
Depending on the actual design, the grass channel weighs approx. 30 kg.
• Loosen the wing nut (1) at the crane splice (2) of the grass channel.
• Raise the crane splice (2) as far as possible and tighten the wing nut (1) to fix it into
position.
Fig. 360
• Position the cable roller guide (3) and use the screw connection (4) to screw it to the lower
cross brace of the rear wall of discharge accelerator (right-hand borehole in the direction of
travel).
• Unwind the rope from the cable winch.
• Guide the rope (5) around the deflection rollers.
To Next Page
Loading...
