Start-up - Maize mode
469
Fig. 375
Notice
The screw connection (2) on the left side on the grass channel must be dismounted first.
The screw connections (2) on the grass channel can be accessed from outside the cooler
compartment.
• Dismount the screw connection (2) on the left side of the machine.
• Dismount the screw connection (2) on the right side of the machine.
• Slowly lower the grass channel using the cable winch (4) until the hole patterns in the rear
wall and the boreholes in the discharge accelerator housing are vertically aligned. In doing
so, the rear wall of the discharge accelerator may have to be manually pressed into the
appropriate position.
• As soon as the corresponding boreholes are in alignment, the spring pressure causes the
spring locks (3) to engage automatically. Check whether the spring locks are fully engaged.
Fig. 376
• Mount the cable deflection (1) using the bolt (2).
To Next Page
Loading...
