Start-up - Maize mode
471
12.3 Installing the corn conditioner
Fig. 379
• Measure roller distance of corn conditioner for calibration before installation, see page 290.
• Make sure that the rear wall is secured by both spring locks (1) left and right.
• Push corn conditioner half way to the side under the forage harvester.
• Fit cable deflection (1) with bolt (2).
• Thread cable (3) into cable deflection (1).
• Guide the cable of cable winch behind the hook (5) along the corn conditioner channel to
the front, between corn conditioner and transport wagon.
Fig. 380
Do not lay the cable (5) outside over axle (1) or round bar (4).
• Guide the cable (5) between cable guide (3) and round bar (4).
• Hook the hook (2) of cable winch into corn conditioner eye.
To Next Page
Loading...
