Start-up – attaching the rear weight
515
16 Start-up – attaching the rear weight
Risk of injury due to unexpected movements when operating the machine!
If the rear weight and the front-mounted EasyCollect front attachment are not coordinated with
each other, there is a risk that the machine may overturn when braked or when driving on
slopes.
• Do not drive the machine on the road or use it for work unless the rear weight, stipulated for
the combination of machine and fitted front attachment, has been attached.
Risk of injury due to suspended load!
There is a danger for persons due to falling load.
• Pay attention to sufficient carrying load of the hoist.
• Do not stay under the suspended load.
• If work has to be performed under the load, securely support the load.
NOTE
The rear weight must only be attached when operating the forage harvester with an EasyCollect
front attachment.
NOTE
When driving with mounted rear weight and without attached header, the machine must only be
moved at walking speed (≤10 km/h).
Fig. 455
The basic weight (2) and the additional plates (1) together form the rear weight (3) that must be
attached to the machine. The additional plates are attached to the basic weight.
The number of basic weights and additional plates required depends on the machine type, the
permissible front axle load and the front attachment type, see the chapter Description of
machine, "Permissible total weights and axle loads".
To Next Page
Loading...
