Start-up – attaching the rear weight
517
Fig. 458
• Using a suitable lifting device, attach the basic weight (1) to the rear bumper of the machine
in such a way that the connecting screws can be mounted.
Use
– the openings for a forklift (3),
– the stop points for a lifting beam (2)
• Ensure that the lifting device chain hooks are correctly attached to the stop points.
• Mount the rear weight (1) using the screw fasteners (4) and (5) below the rear of the
machine (for screw fastening material, see the parts list in the operating instructions for the
front attachment).
NOTE
The suspension points (2) act as a mounting tool for attaching the rear weight to the machine.
Improper use may damage them.
Fig. 459
• Mount the rear weight using the screw fasteners (1) and (3) to the bumper (2) of the
machine (for screw fastening material, see the parts list in the operating instructions for the
front attachment).
• Mount the additional weights (5) from below to the basic weight using the nuts (4) and
washers.
• Measure the tyre pressure using a testing instrument and if required adjust to the stipulated
values, see page 85.
To Next Page
Loading...
