Driving and Transport
537
17.12.2 Folding/raising the front attachment into the transport position
Risk of injury from movement of the front attachment!
If people are in the area of the front attachment when it is being raised or lowered and folded in
or out, there is a risk that these people may be caught and injured by the front attachment or
the lifting unit.
• When the front attachment is moving, ensure that there is nobody in the area of the front
attachment or the lifting unit.
Prerequisites:
– The driver's seat is occupied.
– The diesel engine has been started.
– The release switch road/field is in the "field mode" setting.
– There is nobody in the area of the front attachment.
– The plant divider is fully raised (3-part)/lowered (2-part).
– The maize header is folded in (3-part)/folded on (2-part)
– The guide wheels of the EasyFlow are folded in.
– The holding-down clamp of the EasyFlow is all the way down.
– The guard cloths right/left are mounted.
NOTE
EasyCollect 1053 and XDisc may only be transported with transportation trailers.
During folding/raising, the lifting unit must be in a defined position. There must be sufficient
ground clearance and distance to the cabin roof. This position is approached automatically as
soon as the keys for folding/raising are pressed.
EasyFlow pick-up
For the EasyFlow pick-up, the lifting unit height must be min. 40% and max. 70%.
Fig. 478
To raise the EasyFlow pick-up (3):
• Press and hold down the "Manually raising lifting unit" key (1) on the multi-function lever.
The pick-up (3) is raised as long as the key is pressed.
• When driving on roads with pick-up, raise the pick-up until the distance between lower edge
of pick-up and ground is 450 mm.
To Next Page
Loading...
