Settings
593
Setting the distance between the drum base and cutter
Fig. 522
NOTE
The drum base must be equally set on both sides.
Reducing the gap dimension between the drum base and blades:
• Release the counter nut (2).
• Unscrew the setting screw (1), which reduces the distance between the drum base and the
drum.
• Tighten the counter nut (2).
Increasing the gap dimension between the drum base and blades:
• Release the counter nut (2).
• Screw in the setting screw (1), which increases the distance between the drum base and
the drum.
• Tighten the counter nut (2).
• After setting the drum base, check the dimension "a" and set to 46 mm if required.
To Next Page
Loading...
