Settings
595
Fig. 524
NOTE
An incorrectly set distance between the discharge accelerator and the rear wall will result in
increased fuel consumption and wear of machine components.
• The point of impact (1) of the chopping crops at the top of the channel support should be as
far as possible behind the middle
Setting the upper distance of the rear wall of discharge accelerator
Fig. 525
1 Channel support
2 Wear plate on rear wall of discharge accelerator
3 Rubber buffer
• The rear wall of discharge accelerator should be set so that the distance (a) between the
rear wall wear plate (2) and the channel support (1) is approx. 15 mm but min. 12 mm
To Next Page
Loading...
