Settings
601
Fig. 535
• Loosen the nut (1)
• Set the distance of 5 mm (factory setting) with the two rubber buffers (2) left and right at the
rear wall of discharge accelerator
• Ensure that the distance of the wear plate to the discharge scoops is as uniform as possible
• Readjustment using the left or right rubber buffer (2) may be necessary
• Tighten the nut (1)
NOTE
The transition corn conditioner – rear wall of discharge accelerator must be checked. There
should not be a stacking edge, i.e. the deflector sheet of the corn conditioner must be higher
than the rear wall of discharge accelerator. If this is not the case, a different deflector sheet
must be fitted (repair kit: 150435086, spare part no. deflector sheet: 202265610).
To Next Page
Loading...
