Maintenance – Basic Machine
638
• Connect the rinsing hose (1) to the rinsing nozzle (2) of the silage additives unit and place
the other end in the tank containing the water.
• Move the three-way stopcock (3) to position "I".
• Then pump the water out of the silage additives unit, see page 437
• After rinsing, move the three-way stopcock (3) to position "II".
• Remove the rinsing hose (1) from the rinsing nozzle (2) of the silage additives unit.
• see page 639.
For operating and setting the silage additive system, see page 432.
To Next Page
Loading...
