Maintenance - Gearbox
732
Rear wheel hub gearbox
Oil level check
Fig. 688
• Position the wheel ensuring the oil filler plug (1) is at the top.
• Thoroughly clean the area around the oil filler plug (1).
WARNING! Risk of scalding by hot gear oil escaping under pressure.
• To reduce the pressure, carefully open the oil filler plug (1) from a lateral position.
• Mount the oil filler plug (1).
• Position the wheel ensuring that the lower edge of the filler plug (1) is approx. 40 mm below
the centre of the hub. To do this, position a spirit level horizontally in the centre of the hub
and use a measuring tape to measure the 40 mm.
• Thoroughly clean the area around the oil filler plug (1).
• Dismount the oil filler plug (1).
• Oil level must reach the oil filler plug, if necessary top up oil (see Oil change).
• Re-mount the oil filler plug (1).
To Next Page
Loading...
