Maintenance - Gearbox
735
Oil change
Fig. 690
Prerequisites:
– The machine is shut down and safeguarded, see page 41.
– A suitable container is available for escaping oil.
• Turn the gearbox until the locking screw (1) is in the bottom position.
• Lock the chopping drum, see page 701.
Thoroughly clean the area around the locking screw (1).
• Unscrew the locking screw (1) and drain the oil.
• Unlock the chopping drum, see page 701.
WARNING! Risk of injury due to rotating chopping drum! Do not reach into the chopping drum.
• Turn the belt pulley until the identification "Arrow+UP" (2) is in the top position.
• Lock the chopping drum, see page 701.
NOTE! Possible damage to the gearbox if a mixture of different oils is used.
• Fill gear oil into the filling hole until it escapes. Type of oil and filling quantity, see page 104.
• Fit the locking screw (1).
• Unlock the chopping drum, see page 701.
To Next Page
Loading...
