Krone BiG X 770-3 - Page 806

Appendix – CropControl System
49
Pos: 10.118 /Überschriften/Zwischenüberschriften/A-EAllgemeine Meldungen @ 260\mod_1398864544105_78.docx @ 1986512 @ @ 1
General messages
Pos: 10.119 /BA/Info-Center/CropControl BiG X 600-1100-1/Allgemeine Meldungen CC @ 259\mod_1398694679037_78.docx @ 1981878 @ @ 1
No.
Image
Possible cause
Remedy
A01
– Computer internal plug-in fuse 2
defective.
– Short circuit on voltage output
+12V2FU_L.
– Check wiring for short circuit.
Replace fuse.
A02
– Fuse 3 defective (self-repairing)
– Short circuit on voltage outputs
+12V3FU_L
– Check wiring for short circuit.
A04
EEPROM error
– Job computer defective
– Replace job computer.
A13
Undervoltage back-up battery
– Back-up battery defective
– Check the back-up battery and
replace it, if necessary.
A14
Undervoltage
– Fuse -22F39 defective
– Replace fuse.
A15
Overvoltage
– Alternator is defective
– Check alternator
A16
RAM error
– Back-up battery defective
– Job computer defective
– Check the back-up battery and
replace it, if necessary.
– Replace job computer.
A19
The yield counter for the currently
active cultivated area will soon
overflow (jumps to 0 t).
– The yield counter of the
currently active cultivated area
is active for too long.
– Use another cultivated area or
delete the currently active
cultivated area.
Pos: 10.120 /BA/Info-Center/CropControl BiG X 600-1100-1/Allgemeine Meldung A20 @ 484\mod_1478849264569_78.docx @ 3260949 @ @ 1
A20
– Intake is soiled
– Path sensor is not calibrated
– Clean the intake so that the pre-
compression rollers can be
moved back to the basic position.
– After cleaning is complete,
recalibrate the path sensor.
Pos: 10.121 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1