Krone BiG X 770-3 - Page 809

Appendix – CropControl System
52
Pos: 12.5 /BA/Info-Center/CropControl BiG X 600-1100-1/Statuszeile 1_Calibrate @ 458\mod_1464854971680_78.docx @ 3096243 @ @ 1
Status line (I)
Current states of CropControl are indicated on the top line (I) of the display.
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
Fig. 45
Possible status displays:
Graphic
Meaning
Information
Alarm message present.
Currently active counterweighing for
the displayed order.
CropControl counts yield.
The following conditions must be met
to enable CropControl to count yield:
– Intake is rotating
– Header in working position
– Machine moves forward
– The excursion of the pre-
compression rollers is more than
the set minimum excursion.
The order is started but CropControl
does not count yield.
– An order must be started in the
Task Controller.
– The machine is not currently
harvesting, or insufficient crops
are passing through the machine.
No order is started.
Pos: 12.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1