Appendix – CropControl System
76
Pos: 12.60 /BA/Info-Center/CropControl BiG X 600-1100-1/Menü 1-1 Mindestauslenkung @ 250\mod_1396943525595_78.docx @ 1936372 @ @ 1
Menu 1-1 Minimum Excursion
In menu 1-1 “Minimum Excursion”, you can set from what excursion of the pre-compression
rollers the measurement is started. The higher the minimum excursion setting, the more crops
must flow through the rollers to activate the yield counter.
Fig. 78
Calling the menu
Main menu 1 “Settings” is called.
• Select menu 1-1 by pressing function keys or , the symbol is highlighted in
grey .
• Press function key
.
The display shows menu 1-1 „Minimum Excursion“.
The minimum excursion can be set between 0 and 30 mm.
The guide value to set the minimum excursion is 5 mm.
The symbol in the upper line indicates that the displayed value is saved.
• Increase or reduce the desired value of minimum excursion via function key or , the
symbol in the upper line goes out.
• Press function key .
The symbol in the upper line indicates that the displayed value is saved.
• Pressing the function key closes the called up menu
• Pressing the function key and holding it down brings up the basic screen
Pos: 12.61 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
