Krone Comprima F 155 XC - 1 General Aspects; Intended Use; Technical Data; Manufacturers Address

I - 1
General Aspects
1 General Aspects
These operating instructions contain basic
instructions to follow for assembly, operation and
maintenance. For this reason, these operating
instructions must be read by operating personnel
before commissioning and use, and need to be
available for easy reference.
Follow both the general safety instructions contained
in the section about safety and the specific safety
instructions contained in the other sections.
1.1 Intended Use
The round balers are pick-up balers with baling
chamber. They compact agricultural material, such as
hay, straw or grass silage, into round bales.
1.2 Technical Data
1.2.1 General Aspects
These operating instructions are applicable for the
round balers:
COMPRIMA F 125 ; COMPRIMA F 125 XC
COMPRIMA F 155 ; COMPRIMA F 155 XC
COMPRIMA V 150 ; COMPRIMA V 150 XC
COMPRIMA V 180 ; COMPRIMA V 180 XC
1.2.2Manufacturer’s Address
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Strasse 10
D-48480 Spelle (Germany)
Telephone: +49 (59 77) 935-0
Fax.: +49 (59 77) 935-339
Email: Info.ldm@krone.de
1.2.3 Declaration
EC Declaration of Conformity
corresponding to the EC Directive
See reverse side of title page
1.2.4 Identification
Type
Year of
construction
Vehicle
ID No.
The entire identification plate
represents a legal document and
should not be altered or rendered
illegible!
1.2.5 Data Required for Questions and
Orders
When making questions concerning the machine or
ordering replacement parts, be sure to provide type
designation, vehicle ID number and year of construction.
Genuine replacement parts and
accessories authorized by the
manufacturer ensure safe use. Use of
other parts may void liability for
damage which results.
The machine data are located on a type plate (1) which
is located on the right-hand side of the machine below
the twine compartment.
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Str. 10 D-48480 Spelle
Made in
Germany