II - 1
Safety
2 Safety
2.1 Identifying important Informati-
on in the Operating Instructions
The safety instructions in these operating instructions
that in the case of non-compliance can give rise to
danger for persons are identified with the general
danger symbol:
Safety sign in accordance with DIN 4844 - W9
General function instructions are indicated as follows:
2.2 Safety Instructions and
Accident Prevention Regulati-
ons
2.2.1Personnel Qualification and Training
Persons who use, service or repair the round baler
must be trained in its use and instructed as to the
risks connected with its operation. The operator must
define spheres of responsibility and monitoring of
personnel. Should personnel lack the required
knowledge they must receive the required training
and instruction. The operator must ensure that the
contents of these operating instructions have been
fully understood by personnel.
Repair work not described in these operating
instructions should be completed by authorised
service centres only.
2.2.2Dangers in the Case of Non-
Compliance with the Safety
iInstructions
Failure to follow the safety instructions could result in
personal injury and environmental hazards as well as
damage to the machine. If the safety instructions are
not respected, this could result in the forfeiture of any
claims for damages.
Failure to follow the safety instructions could result,
for example, in the following hazards:
– danger of persons due to not protected working
areas
– breakdown of important machine functions
– failure of prescribed methods for repair and
maintenance
– risk to persons due to mechanical and chemical
effects
– damage to the environment due to leaking
hydraulic oil
2.2.3Safety-Conscious Working
Follow the safety instructions included in these
operating instructions, existing accident prevention
rules and any internal work, operating and safety
rules set out by the operator.
The safety and accident prevention regulations of the
responsible professional associations are binding.
The safety instructions provided by the vehicle
manufacturer should also be observed.
Instructions which are attached to the machine need
to be followed and kept fully legible.
To Next Page
Loading...
